Australian RC Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
332 Posts
Discussion Starter · #1 ·
hm yeah i got ball bearings before to replace the plastic bearings some time ago


there is still grease on the shafts...the 12 bb's in the 2 gear boxes...is that okay?





Edited by: migoreng
 

·
Premium Member
Joined
·
6,579 Posts
BBs don't need greasing on the outside, but if you didn't clean it off when you installed them that's ok too - won't cause any harm. Just messier.
 

·
Registered
Joined
·
332 Posts
Discussion Starter · #3 ·
okay i have cleaned all 24 bb's in the car...
 
G

·
i put a small amount off grease in the gearbob bearings...just so if it happens to heat up, it keeps the sfaft section cooler..



Nismo...
 
1 - 4 of 4 Posts
Top