Australian RC Forums banner
1 - 5 of 5 Posts

·
Premium Member
Joined
·
5,045 Posts
Discussion Starter · #1 ·
finally decided to try the roto so first i countersunk the backplate screws

















You do have to use the 21BB one way bearing though as the fantom one is too big
 

·
Premium Member
Joined
·
2,880 Posts
Husky,


Great tech tip - thanks.


Regards,


Chris
 

·
AUSRC Moderator
Joined
·
6,275 Posts
So have you tried it yet? Do you like it?


Did you countersink the holes with a handheld drill or did you need to use a pedestal drill? What size drill did you need to use?


OK I'll stop asking questions now.
 

·
Registered
Joined
·
1,203 Posts
Sweet as! Now go break it so you can go back to your pull start!
 

·
Premium Member
Joined
·
5,045 Posts
Discussion Starter · #5 ·
I used a hand held drill. Drilled most of the way then grinded the end of the drill bit flat to fet a flat hole bottom. Its pretty soft metal, had no probs drilling it
 
1 - 5 of 5 Posts
Top