Australian RC Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
596 Posts
Discussion Starter · #1 ·
I've had this for a while now. Its currantly gathering dust while i get a engine for it. Also want to get a better servo and receiver for it so i can use my FM radio











 

·
Registered
Joined
·
596 Posts
Discussion Starter · #3 ·
I think i can safely say i spent a bit too much on this one..


The hop up list:






hpi (7551) evo 6 lancer body
hpi (73902) heavy duty chassis
hpi (73017) carbon graphite upper deck
hpi (72171) rear arm brace with stainless steel hinge pins
hpi (72082) centre front universal drive shaft
hpi (72083) centre rear universal drive shaft
hpi (72133) rush outdrives (front only)
hpi (A885) racing clutch
hpi (A912) 2 speed tranny
hpi (A821) 12-15 clutch bell


gpm (NRS402107) front hub carriers
gpm (SN402007) front c hubs
gpm (NRS402207) rear hub carriers
gpm (NRS410007) light wieght flywheel
gpm (NRS4080) pullstart engine mounts
gpm (NRS4200) rs4 2 foam bumper "made" to fit for ankle protection


eureka pro heatsink head for traxxas 15 pro dodgyed onto the leo
eureka pro air filter elbow
eureka pro exhaust coupler
eureka pro red cup washers
eureka pro fuel filter


4x8 bearing for steering crank
lunsford turnbuckles with rpm cups
leo 15 pullstart engine
os (72103110) header
cvec (z125) 12-15 tuned pipe


kyosho shocks plastic
motor saver air filter with raincap
gws (FS-1) failsafe unit
hitec 454bb steering servo
futaba fs 128 throttle servo (about 20 odd years old)
futaba am reciever
kyosho reciever cover
sanwa dash am radio
venom tempreture gauge
tamiya (50839) tgx rally block tires
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top