Australian RC Forums banner
1 - 2 of 2 Posts

202 Posts
Discussion Starter · #1 ·
Hey Engine Tuning Dudes,

Who's got some bright ideas about how to stop your HSN from vibrating around and changing your setting (usually too rich). So far the only thoughts I've had are to loctite it, which seems a bad idea cause some loctite might seep down into the spray bar and gum it up.

The only other idea I've had is to jam something sharp next to the screw to make some friction.

But hey, there must be a better way, right?

let's here some ideas!


If your high speed needle is turning on it own then you might have to get the rubber O-ring kit, because it sounds like they have worn out they do that its a common problem.

Hope this Helps
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.