Australian RC Forums banner

thottle control screwif.

1K views 0 replies 1 participant last post by  slideways 
#1 ·
Ok i dont know how well i can explain this but i'll try. The transmitter i have wont allow full throttle with out the trim. It is a brushed motor. If i have trim set at half, throttle jitters and eventually runs, but only at half pace. If i turn the trim up i need to be constintly on the brake because it wants to run by itself, but i do get full pwer but i then have no reverse. The remote i have seems pretty old in that it only has the two trims and no other adjustments. And it even has a very retro telescopic antenna. But retro is cool nowadays right? Lmao. Is this an issue with out dated transmitter or something else? Its a 2ch if that makes any difference. Was thinking about getting a new one but is this the answer or is the problem going to persist? Thanks.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top