Australian RC Forums banner

baja clutch issuses need major help

3K views 9 replies 5 participants last post by  Kalgoorlie 
#1 ·
Gday so I blew my clutch spring and replaced it and I thought I'd put it in the right way but since loc tighten the nuts it just revs Nd hardly moves so I'm guessing it's in the wrong way is that about right , and apparently I put too much loctite and now I've got a nut locked in and stuffed the head so would I be right in assuming I'm a Dick , hehehe very frustrated
 
#5 ·
After a blow torch a new easy out , hammer and some gentle persuasion I got the bolt out and the clutch is in the correct way , and when it's revved the clutch expands as I assume that's what it should do , so I'm a dumped as to why it revved an idles fine but doesn't move just crawls even on high revs , confused.com
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top