Australian RC Forums banner

Tamiya Nitrage part needed

6K views 8 replies 4 participants last post by  robertcladner84 
#1 ·
Hi all, I'm looking for a starter assembly that goes on the back of a Tamiya Nitrage engine. The part that the Handy start fits into to start the engine. I can't find one anywhere.


Any ideas?
 
#3 ·
That would do. I don't know what would fit it though.
 
#5 ·
Yes Pete. That's the one. Maybe a Force .32 pull start would fit but I'm not sure.
 
#6 ·
What's the bolt spacing and OWB size brett? I have a few rotor start plates here I have no use for, one of them may fit

Sent from my LG-P705 using Tapatalk
 
#7 ·
I'll measure tonight. The car is in a container on the farm where we run. Cheers.
 
#8 ·
Still Looking. :(

Anyone?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top