Australian RC Forums banner

Wheels spinning don't know why

11K views 45 replies 11 participants last post by  PC WIZ 
#1 ·
Hey guys I got some Issue with my car when I start my car my wheels spin wild.
Since the lhs adjusted my engine mounts.

So I thought it was my clutch shoes and spring were the problem so I replaced them and put new ones on so then I reinstalled my engine back on my car everyone looks right I checked sever link brakes my idle and my carb opening.

My remote everything looks fine but why is my wheels still spinning ever since the lhs adjusted my engine mounts what do you guys think? I'm pulling my hair out on what's going on?
 
#35 ·
Some times it's so obvious to on lookers but we are blind to it ourselves.

Good work!
 
#40 ·
Mate - just to clarify so you know how to tune the engine in the future.

You only have a 'high speed' (the one you called high) and a 'low speed' (the one you called mid) mixture adjustment screw. only those two screws will change the air fuel ratio.
the idle screw only changes the idle speed....not the idle mixture.
Steve
 
#39 ·
what you have marked as your mid needle is actually your low speed, its only a mid speed if there are 3 mixture screws plus idle stop. the rest are right
 
#43 · (Edited)
If all else fails in the future mate, set all needles back to factory settings and start again.

After all, the hobby is a learning curve mate.

Glad you have it sorted.

Cheers Dave.
 
#46 ·
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top