Australian RC Forums banner

Slayer pro start up noise

2K views 4 replies 3 participants last post by  towie964 
#1 ·
#5 ·
Try removing it, flush with metho, and dry out completely...once dry re-install, and try to start engine...sometimes they can get gummed up and the rollers dont quite grab

If the above fails, instal a new bearing, they do wear out over time

The one way bearing's job is to help turn the engine over during starting, and then to idle on the starter shaft while the engine is running
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top