Australian RC Forums banner

copper rings supplied with ninja .21

1K views 1 reply 2 participants last post by  Darth D 
#1 ·
Gday all,

Received the Ninja .21 recently and was assembling the pipe to
manifold to engine as per normal, but there are 2 copper rings and a
grub screw left over and I don't know what they are for.

Any ideas?
 
#2 ·
2 spare copper shims. Not sure of the thickness.

And I'm guessing the grub screw is a spare for the Carby uniball joint.

I have just sent you a PM over at Hyperland. If you are going to write down the default settings for the needles & idle would you be able to sent them though? Stupid me didn't do that for some unknown reason & I need to go back to default.

Cheers
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top