: New 5 in 1 not working properly...Pls Help!



Psymon
29-01-2010, 12:10 PM
I finally spent the cash and bought a new 5 in 1 unit for my MCX cause it was no good after many accidents. I have installed it but it isnt working properly. One of the servos rod connector things is right down the bottom of the track (The one that tilts the heli so it can go forward) and the other servos rod connector is in the middle. This means I can only get the heli to hover if i go in FULL reverse on the controller, otherwise it will go forward. I have all my trims at normal levels.

I am not sure if i push the rod that is connected to the offending servo up to the middle (so it matches the other one) if it will stuff something up.

Any ideas??

Dr freedom
29-01-2010, 01:03 PM
you can roll the little wheels at the bottom of each one it before connecting the servo rods, to line them up

Psymon
29-01-2010, 01:58 PM
Yep that was it... thanks alot!