Australian RC Forums banner

my new 50 inch apache

3K views 7 replies 2 participants last post by  benckie 
#1 ·
See less See more
5
#4 ·
well ive been trying to buy some new and used props cheap to get ready for when the apache gets here ive been slowly trying to colect them over the last 2 months since this project started.

sofar ive brought a

Prather S275

Octura x470/2 (still in transit)

ABC 2814/3 Chopper

i still have a

Rmb 7016/3

Rmb 75mm 105mm 2 blade

Prop shop 6714/3

and im still on the hunt for

ABC 2714/3 Cleaver

prop shop 7015/2

i think with one for these 7 or 8 difrent props i should find a all round good one on the apache i would like for it to run around 50 mph
 
#6 · (Edited)
well i got the apache today finaly.











i got this built for my x-mass holiday, life got in the way and it didnt get here in time, after x-mass i was going to shelf it and concerntrate on the other projects ive got going.

i have 3 projects going including this one, and ones going to have to go, so if any ones intrested in this apache pm me as im thinking of putting in the forsale section.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top